D 2011 Job card overview TD 2011 Sorted alphabetically 5 © 01/2009 OBJ_DOKU-24383-001.fm 4/8 Activity Job card Maintenance group Removing and installing the lifting magnet (charge air pressure-dependent full load stop) W 07-08-01 Fuel system Removing and installing the lifting magnet (Engine shutdown) W 11-00-03 Monitoring system Removing and installing the lifting magnet (Start amount release) W 07-02-07 Fuel system Removing and installing the lubricating oil cooler W 08-08-02 Lube oil system Removing and installing the lubricating oil pan (metal sheet lubricating oil pan) W 08-04-07 Lube oil system Removing and installing the lubricating oil pump W 08-04-05 Lube oil system Removing and installing the magnet clip (Exhaust gas recirculation) W 06-09-10 Exhaust system/Charging Removing and installing the oil filter console W 08-11-07 Lube oil system Removing and installing the oil pressure regulating valve W 08-11-02 Lube oil system Removing and installing the oil pressure switch W 08-11-08 Lube oil system Removing and installing the oil suction pipe W 08-04-06 Lube oil system Removing and installing the rocker arm and rocker arm bracket W 01-02-02 Cylinder head Removing and installing the sensor (Exhaust gas recirculation) W 06-09-09 Exhaust system/Charging Removing and installing the starter W 13-03-02 Electrical system Removing and installing the starter W 13-03-02 Electrical system Removing and installing the thermostat (Lubricating oil cooler) W 08-11-12 Lube oil system Removing and installing the toothed belt wheel W 04-04-15 Engine control Removing and installing the turbocharger W 06-06-04 Exhaust system/Charging Removing and installing the V-belt pulley W 12-01-04 Other components Renew camshaft sealing ring (opposite side to fly- wheel) W 04-03-01 Engine control Renew toothed belt and tensioning pulley W 04-04-12 Engine control Renew toothed belt and tensioning pulley (Hydraulic pump) W 12-08-03 Other components Renew V-belts, check V-belt tension W 12-02-01 Other components Renewing the crankshaft sealing ring (flywheel side) W 02-02-02 Drive system Renewing the crankshaft sealing ring (opposite side to flywheel) W 02-02-04 Drive system Renewing the injection lines W 07-03-01 Fuel system Setting valve clearance W 01-01-01 Cylinder head Steuerzeiten prüfen W 04-04-11 Engine control