9 CHECKS BEFORE START C Fuel level audible indication switch (when refueling) 1. With the starter key at the "OFF" position, press the fuel level audible indication switch, and the fuel level can be checked by the buzzer. 2. Start refueling the machine. The buzzer beeping intervals vary according to how much fuel is poured into the tank. As the fuel tank is filled up, the buzzer will sound almost continuously. 3. While refueling the machine, listen to the buzzer to know how much the fuel tank is filled. 4. If fuel is poured too slowly, the buzzer will stop beeping. When resumed normally, the buzzer will start beeping. 5.
To stop refueling halfway (before filling up), press the fuel level audible indication switch or simply stop refueling for a while. The buzzer will stop sounding. C Coolant Temperature Gauge To avoid personal injury: A Do not open the radiator cap during or just after operation. Hot coolant may gush out and scald you. Wait for the coolant to cool down before opening the cap. With the starter key at the " RUN " position, the coolant temperature is indicated. (1) Coolant temperature gauge If the coolant temperature indicator is near " H ", take the steps below. Depending on the coolant temperature, the warning message "Water temp. is rising" or "Overheat Engine to idle for cooling" appears.
In either case too, follow the same procedure below. 1. Discontinue the job. 2. Reduce engine rpm's to idle and keep it at idle for 5 minutes. 3. Stop the engine and check the following points (1)-(4). (1) Low coolant level or leak (2) Fan belt tension (3) Mud or dust deposits on radiator (4) Hydraulic oil leak