Kubota — B LCD Display for Warning

11 CHECKS BEFORE START C Glow indicator The indicator is displayed when the starter key is turned to the "RUN" position but the engine requires preheating. Wait until the indicator goes out, and then start the engine. B LCD Display for Warning C Remaining fuel warning When the fuel level is very low, the lamp (yellow) starts flashing and the following message appears in the display. A After a short period of time, the display comes back to normal. A After a short period of time, the message shows up again. A Even while in the normal display mode, the warning lamp keeps on blinking. A To see what warning is being given out, press the display selector switch.

The current warning can then be identified. (1) Glow indicator B Warning Lamp The warning lamp is used to indicate broken wire, short- circuit, fuel shortage and other problems. The warning lamp starts flashing in red if any problem occurs. If the system senses a in warning signal, the warning lamp starts flashing in yellow. C Battery charge warning If the starter key is turned to the "RUN" position without starting the engine, and the charging lamp stays off, the charging system has failed. If such occurs, immediately contact your local dealer for repair. A If the warning illuminates, do not just look at the meter; carry out the appropriate inspection and correction accordingly.

(See "REGULAR CHECKS AND MAINTENANCE WORK" section) A If any warnings and problems are displayed, an alarm buzzer will beep. (See "LIST OF SCREENS" section for detail.) A See your KUBOTA dealer from details concerning care and maintenance. (1) Charging lamp (1) Warning lamp (red, yellow)