Technical Specifications 3 3.9.2 Fuel, lubricant, and coolant specifications Tab. 11 Fuel, lubricant, and coolant specifications 1 In conformity with the regulation lubricants of the Main Association of the German Building Industry e. V. 30/112 TL160 Operating Manual 12.9.08 Version 1.0 Prescribed fuels, lubricants, and coolants for Central Europe Application Code designation according to Bi 1 Designation Specification, standards, Quality Remarks Engine – Diesel fuel EN 590 ASTM D975 1-D / 2-D Attention Before using RME fuels (rape oil methyl ester), it is essential to consult your responsible Terex dealer for further details.
Engine EO 1540 A Engine oil SAE 15W-40 API CF4 ACEA E3 or E2 See also engine manufacturer's Operating Manual. Hydraulic system HYD 1040 Hydraulic oil or multi-grade engine oil HVLP 46 or SAE 10W-40 The following viscosity limit values must be observed (according to ASTM 445): at 100 °C min. 8 mm2/s (cSt) at –10 °C approx. 1500 mm2/s (cSt) BIO-E-HYD- HEES Biodegradable hydraulic oil on synthetic ester base Filling according to customer specifications. Brand label on machine. The same viscosity specifications apply as for mineral hydraulic oils. Machine damage caused by non-mixable bio oils. • Do not mix bio oils from different manufacturers.
Attention When changing from mineral to biodegradable hydraulic oils, the tank and hydraulic system must be completely drained, cleaned and flushed. For further details before changing oils, please consult your responsible Terex dealer. Axles, Wheel hubs GO 90 LS Transmission oil SAE 85W-90LS API-GL 5 Alternative recommendations SAE 90LS SAE 80W-90LS Lubricating points MPG-A Multi-purpose, lithium-soap based grease K2K-30 DIN 51825 Cooler Mixture of water, additives and glycol Machine damage due to incorrect coolant and mix proportions. Observe the information on the cooling system given in the engine manufacturer's Operating and Maintenance Manual. The antifreeze is factory-set to approx.
-25 °C.