1. DIAGNOSIS TOOLS “ALL ROUND TESTER” 1.1 ALL ROUND TESTER 1.1.4 GENERAL NOTES ON CONNECTING AND POWERING UP THE TESTER To connect the tester to the electronic system of the tractor, proceed as follows: 1 - switch off the engine and remove the starter key; 2 - connect the ART to a diagnosis socket; 3 - insert the starter key and position at “ I ” (ON). When the ART powers up, a page appears showing an in- ternal test run by the instrument to check the battery charge. If the voltage registers less than 10V, the ART does not have sufficient power to connect to the control units, whereas if the value is higher than 15V the instrument could be damaged.
After a few seconds, the tester attempts to connect to the electronic system and displays a page (which may vary de- pending on the tractor or the connector to which it is plugged), from which the technician can choose to con- nect to a given control unit and test the operation of the components. 1.1.5 SELECTION OF THE DISPLAY LANGUAGE The ART is able to display information in a number of different languages (factory setting: ITALIAN). To change the display language, proceed as follows. 1 - Switch off the engine and remove the starter key. 2 - Connect the ART to a diagnosis socket. 3 - Press and hold A on the keypad, while inserting and positioning the starter key at “ I ” (ON).
4 - Enter the password 1 2 3 F . 20-3 S + L + H T E S T E R = = = = = = = = = = = = = = = = V E R S I O N x x x B A T T E R Y T E S T I N P R O G R E S S V O L T A G E x x . x V C O P Y R I G H T 1 9 9 1 E L . E N . S A S M I L A N O = = = = = = = = = = = = = = = = P A S S W O R D :