Vehicle Identification Component Information Label NOTE: Labels shown in this chapter are ex- amples only. Actual specifications may vary from vehicle to vehicle. 1 The component information label lists the vehicle model, identification number, and major component models. It also lists the major assemblies and instal- lations shown on the chassis specification sheet. One copy of the component information label is at- tached to the inside of the glove box; another copy is inside the rear cover of the Owner’s Warranty Infor- mation for North America booklet. An illustration of the label is shown in Fig. 1.1 . 2 06/28/2011 f602081 1. Certification Label 2. Noise Emission Label Fig.
1.2, Label Locations Canadian Motor Vehicle Safety Standard Labels In Canada, tractors with fifth wheels are certified by means of a statement of compliance label with the Canadian National Safety Mark attached to the driver-side door frame B-pillar. See Fig. 1.5 . 06/28/2011 f080173 Fig. 1.1, Component Information Label Federal Motor Vehicle Safety Standard Labels Trucks built without a cargo body and tractors built without a fifth wheel that are intended for service in Canada have an incomplete vehicle certification label (similar to Fig. 1.4 ) attached to the driver-side B-pillar.
After completion of the vehicle, a complete certification label must be attached by the final-stage manufacturer to certify that the vehicle conforms to all applicable Canada Motor Vehicle Safety Standard (CMVSS) regulations in effect on the date of completion. NOTE: Due to the variety of Federal Motor Ve- hicle Safety Standard (FMVSS) certification re- quirements, not all of the labels shown will apply to your vehicle. The FMVSS labels are attached to the driver-side door frame B-pillar, as shown in Fig. 1.2 . Tractors with or without fifth wheels purchased in the U.S. are certified by means of a certification label. See Fig. 1.3 .
Component GWR Label Trucks built without a cargo body that are intended for service in the U.S. have an incomplete vehicle certification label attached by the final-stage manu- facturer. See Fig. 1.4 . This label will be attached to the incomplete vehicle document included with the vehicle, and certifies that the vehicle conforms to all applicable FMVSS regulations in effect on the date of completion. The component GWR label is located on the A-pillar of the driver-side door frame. The label provides maximum GWR ratings for each component. See Fig. 1.6 for a typical component GWR label. 1.1