Personal Protective Equipment (PPE) Do not wear loose clothing and accessories. Secure long hair. These items can snag on controls or on other parts of equipment. Do not wear oily clothes. They are highly flammable. Do not forget that some risks to your health may not be immediately apparent. Exhaust gases and noise pollution may not be visible, but these hazards can cause disabling or permanent injuries. Breathing masks and/or ear protection may be required. HAOA020L Figure 7 Wear a hard hat, safety shoes, safety goggles, mask, leather gloves, earplugs and other protective equipment, as required. While working on machine, never use inadequate tools.
They could break or slip, or they may not adequately perform intended functions. Correction of Machine Problems If any machine problems are found during operation and maintenance (noise, vibration, smell, incorrect gauges, smoke, oil leakage, etc.), or if any abnormal warning alerts are displayed on display monitor, stop the machine and take the necessary corrective actions. Do not operate machine until problem has been corrected. Crushing and Cutting Keep objects away from moving fan blades. Fan blades can throw and cut objects. Do not use a wire rope that is kinked or frayed, or a wire rope with any loss of diameter. Wear leather gloves when handling a wire rope.
When striking a loose retainer pin, it can fly out and can cause a serious injury. Make sure that area is clear of personnel when striking a retainer pin. To avoid injury to your eyes, wear safety goggles when striking a retainer pin. Do not put your hand, arm or any other part of your body between movable parts. If going between movable parts is necessary, always position and secure work equipment so it cannot move. Properly support equipment before performing any work or maintenance under raised equipment. If control levers are operated, clearance between machine and work equipment will change and this may lead to serious damage or can result in death or serious injury.
Stay clear of areas that may have a sudden change in clearance with machine movement or equipment movement. Stay clear of all rotating and moving parts. Unless instructed, never attempt adjustments while machine is moving or while engine is running. Safety 1-19 DX225LC-3