4. MAINTENANCE 4. 8 ENGINE MAINTENANCE To avoid personal injury: Stop, Cool and Clean the engine of flammable materials before servicing. Never service or adjust machine with engine running. 1. Engine Specifications Make...................................................................... Kubota Model ....................................................................V3300T No. of Cyls ...................................................................... 4 Horsepower (Gross) ................................................... 87.4 Power (ISO 9249 Net Power) ..............................61.9 kW Power CE (ISO 9249 Net Power) ........................61.5 kW Max.
High Idle................................................. 2750 RPM Max. High Idle CE ...........................................2500 RPM Max. Torque .....................206 ft. lbs. (280 N·m) @ 1400 Displacement............................... 202.53 in.і (3318 cmі) Engine Oil ................................................ 14 qts. (13.2 L) Firing Order.................................................... 1 - 3 - 4 - 2 Alternator....................................................................60 A Oil Check.................................................................. Daily Oil Change ........................................................... 150 hrs.
Filter Change........................................................ 300 hrs. WARNING Dipstick Location 2. Oil Level Check Check the oil before engine start up. If the engine has been running let it cool for at least 5 minutes. C3783 Fig. 4.8A To check the oil level, stop the engine with the loader on level ground, open the rear door and remove the dipstick (Fig. 4.8A). Keep the oil level between the full and low mark on the dipstick. Do no fill above the full mark. 3. Engine Oil and Filter Replacement Operate the engine until warm, approximately 5 minutes. Stop the engine. Remove the oil drain plug located at the bottom of the oil pan. Remove the oil filter (Fig. 4.8B).
Clean the filter housing surface. Put clean oil on the seal of the new filter and install the filter hand tight. Engine Oil Filter Replace the oil drain plug. Remove the filler cap and add 5W40 API classification CF engine oil. Start the engine and run for 5 minutes. Stop the engine and check for leaks at the filter. Recheck the oil level and add oil until the level is at the top mark on the dipstick. C3786 Fig. 4.8B It Is recommended that you abide by all applicable environmental regulations when disposing of oil. IMPORTANT 50