1. SAFETY PRECAUTIONS CHECK THE CONDITION OF THE SAFETY AND WARNING LABELS 1. Keep the safety and warning labels clean and legible. 2. Wash the labels with soap and water. Dry with a soft cloth. 3. Replace all damaged and lost labels. 4. If a part with a safety or warning label affixed to it needs replacing, ensure the new part also has the warning or safety label. 5. When replacing labels, ensure that the surface beneath is clean, dry and free from oil and grease. 6. Press air bubbles towards the outside edges. C - 360 START SAFELY 1. Sit in the operator’s seat and adjust it so you can operate all of the controls properly.
To avoid personal injury, lower the lift arms, shut off the engine, raise the seat bar and cycle the controls to ensure they are locked. Then, unlatch the seat belt and exit the loader. Do not enter or exit with the engine running unless as specified in this manual or under specific service and backhoe operating procedures. 2. Adjust the seat and fasten the seat belt. Cycle the controls to make sure they are in the locked or neutral position. Lower the seat bar. WARNING 3. Know the exact starting procedure for your machine. See Section 3 for the manufacturer’s instructions for starting.
To prevent personal injury do not operate the loader without lowering the safety bar, fastening the seat belt and keeping feet on the control pedals or cab floor. WARNING To prevent personal injury do not start the engine unless you are in the seat with the seat belt fastened around you. WARNING This engine is equipped with glow plugs. Do not use ether or any high energy fuels to assist starting. IMPORTANT 7