IMPORTANT INFORMATION The shift speed label is attached to the inside of the driver's door. Shift each gear at 10 km/h (6 mph) lower than the recommended shift speed. The shift speed label is not attached. It is recommended that engine speed is restricted to the following: 4HE1-TC, 4HK1-TC : 2,300rpm 4JH1-TC, 4HF1, 4HF1-2, 4HG1 : 2,600rpm 4JB1, 4JB1-TC, 4JG2, 4HG1-T : 2,800rpm Without tachometer: With tachometer: OPERATION OF NEW VEHICLE The subsequent performance and the service life of your vehicle are under the direct influence of the care and treatment that your vehicle will receive during the initial break-in period.
It is therefore always recommended that during the initial 1,000 km (600 miles) break-in period, the following few simple precautions are carefully observed. 1. It is recommended that your speed during initial 1,000 km (600 miles) be confined to the following: - 1–3 - Overloading not only shortens the service life of your vehicle, but also The weight of the payload must be distributed over the front and rear axles so as not to exceed the axle creates serious potential safety limited within the GVM rating and SPECIFICATIONS" for GVM and WARNING Refer to "MAIN DATA AND OVERLOADING Axle capacities. capacities. hazards.