SERVICE LUBRICATION Service Lubrication Grease Lubricating Front Axle Wheel Spindles and Bearings IMPORTANT: Avoid damage! Use recommended John Deere greases to avoid component failure and premature wear. The recommended John Deere greases are effective within an average air temperature range of -29 to 135 degrees C (-20 to 275 degrees F). If operating outside that temperature range, contact your Servicing dealer for a special-use grease. The following greases are preferred:
John Deere Multi-Purpose SD Polyurea Grease John Deere Multi-Purpose HD Lithium Complex Grease John Deere Moly High Temperature EP Grease If not using any of the preferred greases, be sure to use a general all-purpose grease with an NLGI grade No.2 rating. Wet or high speed conditions may require use of a special- use grease. Contact your Servicing dealer for information. Lubricating Seat Lubricating Front Axle Pivot A A MX7699 Lubricate plastic washers and bushings (A) under the seat with a general all-purpose spray lubricant. MX10500 Lubricate front axle center pivot (A) with one or two shots of general all-purpose grease.
Service Lubrication - 30 A B MX770 Lubricate front wheel spindles (A) and bearings (B), n each side, with one or two shots of general all-purpo rease. A B 0 o s