. SAFETY PRECAUTIONS FOR MAINTENANCE switch OFF. Wait for switch to the OFF position. For details, see "HANDLING BATTERY 2 - 36 Removing battery ca Before repairing th electrical welding, approx. 1 minute, t hen remove the negati ve (-) battery cable to stop the flow of electric disconnect SWITCH (PAGE Danger of sparks at sparks will be generated, so always observe the following. There is hazard th Do not let tools around near the When removin connect the pos Tighten the batt Secure the batt There is hazard th at sparks will be genera ted, so alwa ys observe the following. Do not let tools or other metal objects m ake any co ntact between the battery cables. Do not leave tools lying battery.
g the battery cables, remove the ground cable (negative (-) cable) first. When installing itive (+) cable first, then connect the ground. ery cable terminals securely. ery firmly in the specified position. When removin ground itive (+) cable first, the n connect th e ground. ery cable terminals sec Secure the batt ery firmly in the specifie PRECAUTIONS WHEN U SING HAMMER When using a hamm er, pins may fly out or m etal particle s may be scattered. This may lead to serious personal injury or death. . Always do as follows When hitting pins o r bucket teeth, there is a hazard th at broken pieces might be se nt flying and injure peop le in the sur rounding area.
Always chec k that there is no one in the surround ing area. If hard metal parts such as pins, bucket te eth, cutting edges, or bearings are hit w ith a hammer, there is a hazard th at pieces might be scattered and cause serious per sonal injury or death. Always wear safet y glasses and gloves. If the pin is hit with strong force, there is a hazard that it may fly out and injure peo ple in the surrounding area. Do not allow anyone to enter th e surrounding area.
PRECAUTIONS WITH HIGH-TEMPERATURE COOL ANT m spurting out when To prevent burns fro m boiling water or stea checking or draining the coolant, wait for the coolant to c ool down to a temperature whe re the radiator cap can be touched by hand. Then loosen the cap slowly to release the pressure inside the the cap. he radiator, and remove