SPECIAL TOOLS I ~ EF~ ~ I CIRCLIPS 1. All circlips should be inspected carefully be- fore reassembly. Always replace piston pin clips after one use. Replace misshapen circlips. When installing a circlip CD , make sure that the sharp edged corner ® is positioned opposite to the thrust ® it receives. See the sectional view. 300-001 @ Shaft SPECIAL TOOLS The some special tools are necessary for complete accurate tune-up and assembly. Using the correct special tool will help prevent damage thet can be caused by the use of improper tools or improvised techniques. NOTE:
______________________ ___ Be sure to use the correct part number when ordering the tool, since the part number differs according to the area as shown below. The first part number is for Europe, and the last part is for the U.S.A. and Canada. e.g. 90890 - *****, YU- ***** FORTUNE UP 1. Vacuum Gauge PIN -, YS-33275 Thisgauge is used for carburetor synchronization. 2. Sheave Gauge PIN -, YS-91047 CD PIN - , YS-33274 ® This gauge is used to measure sheave distance and for offset adjustment. 1-4 http://ReadManuals.com