Vehicle Identification Vehicle Specification Decal 1 2 3 The vehicle specification decal ( Fig. 1.1 ) lists the ve- hicle model, identification number, and major compo- nent models. It also recaps the major assemblies and installations shown on the chassis specification sheet. One copy of the specification decal is at- tached to the inside of the glove box; another copy is inside the rear cover of the Owner’s Warranty Infor- mation for North America booklet. 11/21/96 f080053 1. Date of manufacture by month and year. 2. Gross vehicle weight rating; developed by taking the sum of all the vehicle’s gross axle ratings. 3.
Gross axle weight ratings; developed by considering each component in an axle system, including suspension, axle, wheels, and tires. The lowest component capacity is the value used for the system. COMPONENT INFORMATION MANUFACTURED BY MODEL VEHICLE ID NO. USE VEHICLE ID NO. WHEN ORDERING PARTS Fig. 1.2, Certification Label, U.S. DATE OF MFR ENGINE MODEL TRANS MODEL MAIN FRONT AXLE MODEL REAR AXLE MODEL WHEELBASE ENGINE NO. TRANS NO. FRT AXLE NO. REAR AXLE NO. REAR AXLE NO. RATIO PAINT MFR PAINT NO. IMRON PAINT−CAB CAB COLOR A: WHITE (4775) CAB COLOR B: BROWN (3295) CAB COLOR C: BROWN (29607) CAB COLOR D: DARK BROWN (7444) FOR COMPLETE PAINT INFORMATION SEE VEHICLE SPECIFICATION SHEET PART NO.
24−00273−010 Fig. 1.1, Vehicle Specification Decal, U.S.-Built Vehicle Shown f080021 11/21/96 NOTE: Labels shown in this chapter are ex- amples only. Actual specifications may vary from vehicle to vehicle. Federal Motor Vehicle Safety Standard (FMVSS) Labels NOTE: Due to the variety of FMVSS certification requirements, not all of the labels shown will apply to your vehicle. Tractors with or without fifth wheels purchased in the U.S. are certified by means of a certification label ( Fig. 1.2 ) and the tire and rim labels. These labels are attached to the left rear door post, as shown in Fig. 1.3 . 1. Tire and Rim Labels 2. Certification Label Fig.
1.3, Location of Labels If purchased for service in the U.S., trucks built with- out a cargo body have a certification label ( Fig. 1.4 ) attached to the left rear door post. See Fig. 1.3 . In addition, after completion of the vehicle, a certifica- tion label similar to that shown in Fig. 1.2 must be attached by the final-stage manufacturer. This label will be located on the left rear door post and certifies that the vehicle conforms to all applicable FMVSS regulations in effect on the date of completion. 09/28/98 f080023 Fig. 1.4, Incomplete Vehicle Certification Label, U.S. 1.1 02/02/95 1 2 f600061b