WEICHAI & PSI SERVICE MANUALS AVAILABLE ONLINE AT FLYPARTSGUY.COM One 12V battery is used to provide 12V to the control system. The battery needs to be setup according to the steps below: - Engine Electrical System is 12-volt DC Negative Ground - The Engine Battery should be 650CCA or Greater. Never disconnect the battery when running. The batteries should be attached to the engine at all times. - Connect positive (+) red wire to positive (+) terminal on battery. - Connect negative (-) black wire to negative (-) terminal on battery.
CANBUS J1939 INTERFACE CONNECTING WITH ZTR TELEMATICS Figure 8 CANBUS J1939 Interface Connection with ZTR Telematics INTAKE AIR SYSTEM The intake system should be sealed between the mixer inlet and the filter. Proper clamps should be used to ensure unfiltered air is not drawn into the system. Use piping with minimum diameter equal to mixer inlet. When in an enclosure it can sometimes be necessary to use an externally mounted filter. It can be beneficial to engine life and performance to draw in air from the coolest location possible WEICHAI EMISSION-RELATED INSTALLATION INSTRUCTIONS GET YOUR WEICHAI & AFTERMARKET SERVICE PARTS AT FLYPARTSGUY.COM