OPERATION Fueling This product is powered by a 2-cycle engine and requires pre- mixing gasoline and 2-cycle oil. Pre-mix unleaded gasoline and 2-cycle engine oil in a clean container approved for gasoline. RECOMMENDED FUEL: THIS ENGINE IS CERTIFIED TO OP- ERATE ON UNLEADED GASOLINE INTENDED FOR AUTOMO- TIVE USE WITH AN OCTANE RATING OF 87 ([R + M] / 2) OR HIGHER. Mix JOHN DEERE Premium Exact Mix™ Oil with gasoline according to the instructions on the package. If Premium Exact Mix™ oil is not available, use a high quality 2-cycle engine oil, mixed at 2.6 oz. per gallon (US). DO NOT USE AUTOMOTIVE OIL OR 2-CYCLE OUTBOARD OIL. NOTE:
Premium Exact Mix™ fuel mix contains a fuel stabilizer and will stay fresh up to 30 days. DO NOT mix quantities larger than usable in a 30 day period. A 2-cycle oil containing a fuel stabilizer is recommended. 3. Carefully pour fuel mixture into the tank. Avoid spillage. 4. Prior to replacing the fuel cap, clean and inspect the gasket. 5. Immediately replace fuel cap and hand tighten. Wipe up any fuel spillage. 6. It is normal for smoke to be emitted from a new engine during and after first use. WARNING Check for fuel leaks, if any are found, correct before use.
Fuel Mixture Fuel Mixture Premium Exact Mix ™ (50:1) Gasoline Oil 1 gallon (US)..............................................2.6 oz. 1 Liter ........................................................20cc (20 ml) 2.6 oz. } 1 pt. OR Chain Oil System 1. Use JOHN DEERE Bar and Chain Oil. It is designed for chains and chain oilers and is formulated to perform over a wide temperature range with no dilution required. If not available, use any new SAE-30 weight engine oil. NOTE: Do not use dirty, used or otherwise contaminated oils. Damage may occur to the oil pump, bar, or chain. 2. Fill the oil tank every time engine is fueled. 3.
The automatic oil pump is a positive displacement pump operated through gears driven off the clutch drum assembly. The pump will not oil at idle speeds. 4. Chain saw should use approximately one tank of oil per tank of fuel. 2.6 oz. Filling the Tank WARNING Always shut off engine before fueling. Never add fuel to a machine with a running or hot engine. Move at least 10 feet (3m) from refueling site before starting engine. DO NOT SMOKE! Refer to the Safety-Refueling Section for additional Safety Precautions. 1. Clean surface around fuel cap to prevent contamination. 2. Loosen fuel cap slowly. Bar and Chain Oil 12 English