16. TROUBLESHOOTING Connecting the booster cables Keep the starting switch at the OFF position. Connect the booster cable as follows, in the order of the numbers i >, = 6 ran ib 5 A 5 marked in the diagram. 1. Make sure that the starting switches of the normal machine and . eas problem machine are both at the OFF position. 2. Connect one clip of booster cable @ to the positive (+) terminal of Battery ofthe é Battery of the Brog§: blem machine Engine block ot the SL problem machine toaews the problem machine. 3. Connect the other clip of booster cable @ to the positive (+) terminal of the normal machine. 4.
Connect one clip of booster cable © to the negative (-) terminal of the normal machine. 5. Connect the other clip of booster cable ® to the engine block of the problem machine. 1. Make sure the clips are firmly connected to the battery terminals. 2. Start the engine of the normal machine and keep it to run at high idling speed. 3. Turn the starting switch of the problem machine to the START position and start the engine. If the engine doesn't start at first, try again after 2 minutes or so. 2-92 PC160/180/200-6k-ENG Starting the engine