24. SERVICE PROCEDURE 24.2 CHECK BEFORE STARTING 24.2.1 CHECK COOLANT LEVEL, ADD WATER A WARNING Do not open the radiator cap unless necessary. When check- ing the coolant, always check the radiator reserve tank when the engine is cold. 1. Open the rear door on the left side of the machine and check that the cooling water level is between the FULL and LOW marks on radiator reserve tank @) (shown in the diagram on the right). If the water level is low, add water through the water filler of reserve tank @ to the FULL level. 2. After adding water, tighten the cap securely. 3. Ifthe reserve becomes empty, first inspect for water leaks and then fill the radiator and the reserve tank with water.
24.2.2 wt LOW CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL 1. Open the engine hood. 2. Remove dipstick © and wipe the oil off with a cloth. 3. Insert dipstick @ fully in the oil gauge 4. The oil level should be between the H and L marks on dipstick @. If the oil level is below the L mark, add engine oil through oil filler ©. A : pipe, then take it out again. For details of the oil to use, see 20. “USE OF FUEL, COOLANT LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. AND * PC160/180/200-6k-ENG FBtt2 3-45