12. OPERATION 12.2.2 STARTING IN COLD WEATHER A WARNING ¢ Check that there are no persons or obstacles in the surround- e Never use starting aid fluids as they may cause explosions. for about 2 minutes. When starting in low temperatures, do as follows. 1. Set fuel control dial @ oe Ae ee Ee NOTICE Do not keep the starting motor rotating continuously for more than 20 seconds. If the engine fails to start, repeat from step 2 and after waiting ee, ing area, then sound the horn and start the engine. at the low idling (MIN) position. FresIS 2. Hold the key in starting switch @ at the HEAT position, and check that preheating monitor ®@ lights up.
After about 30 seconds, preheating monitor lamp @ will flash for about 10 seconds to indicate that preheating is finished. REMARK The monitor and gauge also light up when the key is at the HEAT PC160/180/200-6k-ENG position, but this does not indicate any abnormality. 2-49