21 . Fit the valve cover using a new gasket . Make sure that the round hole for the crankcase ventilation is in the right position . Fit the decompression device lever . Fit the presure pipes between the injectors and the injection pumps . Also refit the inlet air silencer . 19 . Install the sea-water pump and the cooling water pipes . 20 . Install the injectors and the return fuel pipe . Tightening torque for the injectors 20 Nm (2,0 kpm) (14 .7 ft .lbs .) . Also 22 . Install the starter motor, the alternator and the install the exhaust elbow and the water pipe between the thermostat housing and the exhaust elbow . alternator V-belt .
Also install the electrical distribution box and hook-up the cable harness .