Flywheel/Flywheel NOTE: P218G or P220G engine, flywheel and shield are not shown. 2. Install flywheel shield, if removed, and fasten with five cap screws. M36294 -UN-29JAN90 M98,2020K,11 -19-30JAN87 CTM2 (19APR90) 20-5 16, 18, 20 & 24HP Onan Engines AllTractorManuals.com 130495 IMPORTANT: Do not lubricate crankshaft taper. The crankshaft taper must be dry to hold the flywheel tight. 3. Clean crankshaft taper before installing flywheel. -UN-29JAN90 4. Apply pipe sealant on threads of flywheel cap screw. 5. Align keyway (A) in flywheel with key (B) in crankshaft. Install flywheel. M36297 6. Install washer and cap screw. 7. Fasten locking pliers to ring gear to prevent flywheel from turning. 8.
On B43E, B43G, B48G, and T260 Engines: Tighten cap screw to 51 ± 3 N·m (38 ± 2 lb-ft). -UN-29JAN90 On P218G and P220G Engines: tighten cap screw to 67—75 N·m (50—55 lb-ft). M36298 M98,2020K,12 -19-10FEB85 20 5