. SAFETY SAFETY MAINTENANCE INFORMATION WHEN USING HAMMER turning off the engine starting 2 - 38 When using a hammer, pin s may fly out or metal particle s may be scattered. This may lead t o serious injury. Always do a s follows. If hard metal parts such as pins, bucket teeth, cutting edges, or bearings are hit with a h might be scattered an glasses and gloves. When hitting pins or buc ket teeth, there is a hazard th at broken pieces might be sent flyi ng and injure people in the su rrounding area. Always check that there is no one in the surroun dingarea.
There is a hazard that t ut and injure people in the WELDING WORKS Welding operations must al ways be carried out by a quali fied welder and in a place equipped with proper equipment There is a hazard of gas, fir e, or electrocution when carr ying out welding, so neve r allow any unqualified per sonne to carry out welding. REMOVING BATTERY TER When repairing or welding switch key, and then disco nnect the negative (-) termina l of the battery to stop th SAFETY FIRST WHEN USING HIGH-PRESSURE GREASE TO ADJUST TRACK TEN Grease is pumped into under high pressure.
If the specified procedur e for maintenance is not follo wed when making adjustment, grea se drain plug (1) may fly out a nd cause serious injury or property When loosening greas tension, never loosen it more than one turn. Loosen t he grease drain plug slowly. Never put your face, han ds, feet, or any other part of your body close to grease drain plu