Safety Section Never put maintenance fluids into glass containers. Use all cleaning solutions with care. Do not use steam, solvent, or high pressure to clean electrical components. Report all needed repairs. Inspect the part of the chain that is normally operated over the crosshead roller. When the chain bends over the roller, the movement of the parts against each other causes wear. Inspect to be sure that chain link pins do not extend outside of the bore hole. If any single link pin is extended beyond its connecting corresponding link, it should be suspected of being broken inside of its bore hole. Inspect the chain anchor and the anchor links for wear.
Do not change any factory set adjustment values (including engine rpm setting) unless you have both authorization and training. Especially Safety equipment and switches may not be removed or adjusted incorrectly. Repairs, adjustments and maintenances that are not correct can make a dangerous operating condition. For any checkup, repair, adjustments, maintenance and all other work concerning your forklift truck, please contact your DOOSAN dealer. We would like to draw your attention to the fact that any secondary damages due to improper handling, insufficient maintenance, wrong repairs or the use of other than original DOOSAN spare parts waive any liability by DOOSAN.
Operation Information Mounting and Dismounting Mount and dismount the lift truck carefully. Clean your shoes and wipe your hands before mounting. Face the lift truck when mounting and dismounting. Use both hands face the lift truck when mounting and dismounting. Use the handgrips for mounting and dismounting. Do not try to climb on or off the lift truck when carrying tools or supplies. Never get on or off a moving lift truck. Do not use any controls as handholds when entering or leaving the operator's station. Never get on or off a moving lift truck. Never jump off the lift truck. Keep hands and steering wheel free of slippery material.
Before Starting the Lift Truck Perform a walk-around inspection daily and at the start of each shift. Refer to the topic “Walk-around Inspection” in “Every 10 Service Hours or Daily” section of this manual. Adjust the seat so that full brake pedal travel can be obtained with the operator's back against the seat back. Make sure the lift truck is equipped with a lighting system as required by conditions. Make sure all hydraulic controls are in the HOLD position. Make sure the direction control lever is in the NEUTRAL position. Make sure the parking brake is engaged. Make sure no one is standing and/or working on, underneath or close to the lift truck before operating the lift truck. 11