Steering Lock This switch allows the operator to oper- ate the ATV in either two-wheel drive (rear wheels) or four-wheel drive (all wheels). For normal riding on flat, dry, hard surfaces, two-wheel drive should be sufficient. In situations of aggressive trail conditions, four-wheel drive would be the desired choice. To either engage or disengage the front wheels, move the switch to the 4WD position or to the 2WD position. ACE-027A This model is equipped with a steering lock located directly above the power steering motor. To lock the steering, turn the handlebar fully left, insert the key into the lock, and turn key counterclock- wise; then remove the key.
To unlock the steering, insert the key into lock and turn the key clockwise; then remove the key. NOTE: Make sure the key is removed after locking the steering. CAUTION Do not attempt to either engage or dis- engage the 4WD lock while the ATV is moving. The 4WD lock allows the operator to mechanically lock the front differential to apply equal power to both front wheels. To engage the lock from 4WD, slide the switch up and move fully to the left. To disengage the lock, move the switch Shift Lever CF130B This ATV has a dual-range automatic transmission with reverse.
Foot Brake Pedal (Main Brake) Drive Select Switch FI475A CF117 Pressing the foot brake pedal downward will apply brakes to all wheels. 35 lever to the right. DIVISION II - OPERATION/ MAINTENANCE ! WARNING The 4WD lock is intended for use where minimum traction is avail- able. NEVER EXCEED 10 MPH (16 kph) with the lock engaged. Maneu- verability and handling characteris- tics will differ with the lock engaged. Failure to follow this pro- cedure may result in loss of control. Control loss can result in severe injury or death.