Hazard Lights Switch ! WARNING Always check to be sure that the emergency/parking brake has been disengaged before operating the ATV. An accident could result if the emergency/parking brake is left engaged while the ATV is operated. This could cause an accident. Headlight Switch ATV-004C To activate the hazard lights, press and release the hazard light switch. To deacti- vate the hazard lights, press and release the hazard light switch again. Winch Switch ACE-004A Use the headlight switch to select the high or low headlight beam or parking lights when the ignition switch is in the LIGHTS position. When the switch is in the HI position, the high beam will illu- minate.
When the switch is in the LO position, the low beam will illuminate. When the switch is in the PARKING position, the front and rear lights will illuminate. DIVISION II - OPERATION/ MAINTENANCE ACE-017 To release the cable, slide the toggle switch to the left; to spool-in the cable, slide the switch to the right. Turn Signal Switch Horn Button ATV-004D To activate the horn, press the horn but- ton. ATV-004B To activate the turn signals, slide the turn signal switch to the direction of the desired turn. When the turn is completed, return the switch to the center (OFF) position. 37