NOTE: Both the ignition and fuel pump functions will be interrupted by the Tilt Sensor if the ATV tips over past 60°-70°. Righting the ATV will reactivate the ignition and fuel pump. Rear Seat Lock 1. To remove the rear seat, pull the two latch handles to the rear and rotate them to the vertical position. Gas Hose Replace the gas hose every two years. Dam- age from aging may not always be visible. Oil Level Stick CF226 2. Lift the rear of the seat up; then pull slightly to the rear and lift the seat off the mountings. ATV-0100AA There is an oil level stick for checking the engine oil level. To check the oil level, use the following procedure. NOTE:
The ATV should be on level ground when checking the engine oil level. 3. To lock the seat into position, engage the two front mounting lugs into the mounting rack; then, hold- 1. Unscrew the oil level stick and wipe it with a clean cloth. 2. Install the oil level stick and thread it into the engine case. 3. Remove the oil level stick; the engine oil level should be above the “L” mark but not higher than the “F” mark. CAUTION Do not overfill the engine with oil. Always make sure the oil level is above the “L” mark but not higher than the “F” mark. Front Seat Lock NOTE: On the TRV, the rear seat must be removed prior to removing the front seat.
Mirrors The mirrors can be adjusted to the desired viewing angle or moved to a stowed position when operating in trees or brush. ! WARNING Always adjust the mirrors to a position that will not catch tree branches or under-brush which could cause a loss of control and severe injury or death. CR010A 41 ing down firmly on the front of the seat, push the seat forward until the rear tabs engage the rear mounting latches. 4. Lock the seat into position by rotat- ing the latch handles to the horizon- tal position; then push the handles forward to lock. DIVISION II - OPERATION/ MAINTENANCE ! WARNING Make sure the seat is secure before mounting the ATV.
Severe injury may result if the seat is not properly secured.