CAUTION After operating the ATV for the initial 5-10 minutes, stop the engine, allow the engine to cool down, and check the coolant level. Add coolant as nec- essary. The shock absorber has a spring force adjustment sleeve with five adjustment positions to allow the spring to be adjusted for different riding and loading conditions. If the spring action is too soft or too stiff, adjust it according to the chart. NOTE: Before attempting to adjust suspension, clean dirt and debris from the sleeve and remove load from the suspension; then use the spanner wrench to adjust the sleeve to the desired position. Oil Cooler NOTE:
Dirt and debris must be cleaned from the cooling fins regu- larly to ensure proper engine oil cooling. KC0083 General Lubrication Cables None of the cables require lubrication; however, it is advisable to lubricate the ends of the cables periodically with a good cable lubricant. CAUTION Continued operation of the ATV with high engine temperature may result in engine damage or premature wear. Engine/Transmission Oil and Filter NOTE: High engine RPM, low vehicle speed, or heavy load can raise engine temperature. Decreas- ing engine RPM, reducing load, and selecting an appropriate transmis- sion gear can lower the tempera- ture. NOTE:
Refer to the recommended oil viscosity chart (on page 43) in this manual for the proper engine oil. Change the engine oil and oil filter at the scheduled intervals. The engine should always be warm when the oil is changed so the oil will drain easily and completely. Shock Absorbers Each shock absorber should be visibly checked weekly for excessive fluid leak- age (some seal leakage may be observed but it does not indicate the shock is in need of replacement), cracks or breaks in the lower case, or a bent shock rod. If any one of these conditions is detected, replacement is necessary. NOTE:
When the ATV is operated in extremely cold weather (-23°C/-10°F or colder), a small amount of leakage may be present. Unless the leakage is excessive, replacement is not nec- essary. 1. Park the ATV on level ground. 2. Remove the oil level stick. Be care- ful not to allow contaminates to enter the opening. 46 CF109M Position Spring Force Setting Load 1 Stronger Soft Stiff Light Heavy 2 3 4 5