. OPERATION DETAILED CONTROLS AND GAUGES Gauges and Meter REMARK Only segment (D) flashes, and the alarm buzzer sounds at the same time. if for each 1/10 hour of operation 3 - 8 Engine Coolant Temperature Ga uge cooling water tempoerature. This meter (2) shows the engine cooling water t During nor mal operation, the lamp should light up in the green range (A). If the lamp i n the red range (B) l ights up during operation , run the engine at lo w idling and wait for the temperature to go dow n to the green range (A). e engine after start-up until the temperature goes up ite range (C) to the green range (A). Warm up th from the wh ite range (C) to the green range (A).
Fuel Gauge (3) shows the fuel level in the fuel tank. mal operation, the lamp should light up in the green This meter (3) shows the fuel le vel in the fuel ta During nor range (A). If the lamp i n red range (B) flash es during opera tion, ther e is l ess than 19 lite fuel. rs (5.02 US gal) of fuel remaining, so check and add add The correct level may not be di splayed for a sh ort time after the starting swi tch is turned to the ON position,but this is not any . any abnormality Service Met er This meter (4) shows the total o peration hours o f the machine Set the peri odic maintenance in tervals using this display. The service meter advances wh e is not traveling.
running the machin While the e ngine is running,ope ration display (A ) at the to p inside of the mete r will light to show th at the meter is a dvancing . The meter will advance by 1 regardless of the engine speed.