Operation—Operator's Station Monitor Panel 1. Engine Coolant Temperature Gauge: 2 1 IMPORTANT: If needle points to "RED" zone, idle engine to bring back needle to "GREEN" zone before stopping engine. If needle continues to rise, shut engine OFF. 22 2. Fuel Gauge: Fuel machine before needle reaches “E”. 3. Display Select Switch: Press switch to display Hour Meter, Trip Meter 1 or Trip Meter 2 information in that order on the monitor display. 21 DISPLAY SELECT 4. Set Switch: Press switch to change settings in Trip Meter 1 or Trip Meter 2. 19 20 3 SET 4 5. Work Mode Switch: Press switch to select Dig Mode or Dig Mode II. 18 WORKMODE Dig Mode- - - - - - -Used in normal digging operations.
17 5 6 Dig Mode II- - - - - Used in trench digging operations (faster swing and slower boom). 16 7 6. Fuel Level Indicator: 14 15 8 T140046 —UN—20MAR01 IMPORTANT: DO NOT allow machine to be run out of fuel. Engine will not start until air has been completely purged from fuel system. 13 9 12 10 Indicator will light when approximately 80 liters (20 gal) of fuel remain. 11 7. Air Filter Restriction Indicator: Indicator will light when the air filter elements are clogged.
1— Engine Coolant Temperature Gauge 2— Fuel Gauge 3— Display Select Switch 4— Set Switch 5— Work Mode Switch 6— Fuel Level Indicator 7— Air Filter Restriction Indicator 8— Alternator Voltage Indicator 9— Check Engine Indicator 10— Hydraulic Oil Filter Restriction Indicator—If Equipped Precision Mode Indicator 12— Engine Coolant Level Indicator 13— Engine Oil Level Indicator 14— Engine Oil Pressure Indicator 15— Pre-Heat Indicator (not used) 16— Engine Coolant Temperature Indicator 17— Attachment Mode Indicator (not used) 18— Dig Mode Indicator 19— Dig Mode II Indicator 20— Monitor Display 21— Auto-Idle Indicator 22— Auto-Acceleration Indicator 8. Alternator Voltage Indicator:
Indicator will light with no or low alternator output. 9. Check Engine Indicator: Indicator will flash when the engine derate reaches 50% due to the following conditions: Low fuel pressure, high fuel temperature, crank sensor fault, defective fuel injection pump ECU, or a failure in ECU to injection pump ECU communications. 10. Hydraulic Oil Filter Restriction Indicator—If Equipped: Indicator will light when main hydraulic filter element is restricted. 11. Precision Mode Indicator: Indicator will light when Precision Mode is selected. NOTE: Cold oil, low oil level, or extreme off level operation may cause indicator to light. 12. Engine Coolant Level Indicator:
Indicator will light if engine coolant level is low in recovery bottle. 13. Engine Oil Level Indicator: Indicator will light if engine oil level is low. 15. Pre-Heat Indicator: Not used. 14. Engine Oil Pressure Indicator: 16. Engine Coolant Temperature Indicator: IMPORTANT: If light comes on while operating, stop engine immediately. IMPORTANT: DO NOT stop engine when light comes on or temperature will rise further. Reduce load and run engine at slow idle. If light stays ON, stop engine. Indicator will light and buzzer will sound when engine oil pressure is low. Stop engine immediately. 2-1-2 060313 PN=30 Continued on next page VD76477,0000106 -19-29JUN06-1/2