SECTION 1 INTRODUCTION Page 4 INTRODUCTION GENERAL Throughout this manual there will be two types of cross references. One type - numerical - refers to a heading within the same section. The other type - numerical followed by the section title - refers to a heading in another section. Refer to the section contents page at the beginning of the individual sections for specific page numbers. Throughout this manual the use of the terms "left", "right", "front", and "rear" must be understood to avoid confusion when following the instructions. "Left" and "right" indicate the left and right sides of the machine when facing forward in the operator's seat.
The „front” is in front of the operator, the „rear” - behind his back. See Fig. 1.1, 1.2. Some illustrations are of general application of this model and may not show your machine accurately in all details. The loaders are available in 2 different versions: 1. standard version equipped with a mechanical feedback steering and a hydraulic system controlled with either 2 or 3 levers mechanically connected with a 2 or 3-spool control valve respectively. 2. upgraded version: equipped with a hydraulic feedback steering and a hydraulic system controlled with 1 or 2 levers hydraulically connected with a 2 or 3-spool control valve respectively.
In this version it can be configured as CE version according to EC directives. WARNING!: This symbol and text in bold letters is used throughout this manual to call your attention to instructions concerning personal safety. Observe and follow these instructions. Be certain anyone operating and servicing this machine is aware of these rules. Failure to follow these rules may result in injury or death. IMPORTANT: This sign and text in italics is used throughout this manual to call your attention to key problems for machine operation. Failure to follow such instructions may result in damage of the machine and heavy material losses. NOTE:
This sign and text in italics is used throughout this manual to call your attention to important function having influence on the right functioning of the machine or for informational purposes. OM515C520C99/1E DRESSTA