SAFETY PRECAUTIONS SECTION 2 Page 7 2.4. GENERAL MAINTENANCE PRECAUTIONS Replace any missing or defaced product graphics. When parts which have product graphics on them are replaced, be sure to install new product graphics. New product graphics are available from the Authorized Distributor of Construction Equipment. Never let anyone near the machine's articulation pivot. If the machine is turned, they could be crushed. Before servicing the machine use the frame safety bar to prevent accidental articulation.
Before servicing the machine, be sure the engine is off, the bucket is lowered, the transmission shift lever is locked in neutral (N), the electrical system master switch is off and the key is removed. Tag the machine. Use only approved parts for repairs and maintenance. Failure to do so could compromise personal safety, machine performance, and reliability. Before working under the machine, block the tires to prevent machine movement. It is not possible to anticipate all conceivable ways or conditions under which this machine may be serviced or to provide precautions for all the possible hazards that may result. Safety is always the most important rule.
Constantly be aware of dangers involved in working on the machine and take proper precautions. Standard and accepted safety precautions and equipment should be used. Never attempt to start servicing close to the operating fan as it may result in serious injury. When changing cutting edges, securely support the bucket for your protection. If the bucket is provided with teeth, use special hammer for installation to prevent teeth breakage. Wear safety goggles. Lift and handle all heavy parts with lifting devices of adequate capacity. Secure the parts with proper slings and hooks. Use lifting eyes provided. Warn the nearby personnel to stand clear. Keep work area clean and dry.
Remove water and oil spills immediately to reduce the chance of slipping and injury. Do not pile up oily or greasy rags; they are a fire hazard. Store them in an approved, closed metal container. Do not carry loose objects in your pockets because they might catch on the machine and result in a fall or injury. Use the proper tool for the job. Be sure all tools are in good condition. Do not use tools which are worn, bent or have mushroomed heads because they can lead to injury. Do not use the loader bucket or forks to lift personnel or as a work platform.
When service requires access to areas that cannot be reached from the ground or service platform on the machine, use a ladder or platform of adequate size and capacity. Never adjust relief valves higher than the specified pressure because this may damage the machine and lead to injury. When checking pressures, use the correct gauge for the expected pressure. Consult the Authorized Distributor of Construction Equipment DRESSTA OM515C520C99/1E