Command Center Setting Implement Selection Press vehicle Settings Switch (A) to view menu items on Display (D). Rotate Command Dial (B) to highlight desired menu item and press Select Switch (C). D C B Menu Items on Display (D) Implement Select Code RXA0085829 —UN—27JAN06 English Translation (if applies) Manual Manual Auto Seek (Default) — Auto Seek (Default) Impl Switch: AS Impl Switch: AS RPTO RPTO HCU HCU SCV IV SCV IV A A—Vehicle Settings Switch B—Command Dial C—Select Switch D—Display chosen device or system is engaged. Once selected and engaged, measuring cannot be turned off until the chosen device or system is disengaged.
When Auto Seek is selected, the first detected ”engaged” signal seen by the control unit causes the implement arrow to point down and start accumulating measurements (distance and area). The code of the first detected device will highlight on the screen and change back to Auto Seek when that device is disengaged or, change to a different code if another device is already engaged. is shown at the end of implement code to indicate that the highlighted implement is engaged via the auto seek function. IMPLEMENT SEL:
Identifies a device or system that supplies a feedback signal for measurement related bottomhalf screens, such as Total Area, AreaperHour or Distance, all of which include the implement position arrow. Position arrow indicates if implement is raised (arrow up) or lowered (arrow down). Measurements are being recorded only when the implement arrow is down. When HCU, SCV I, II, III, IV, V or RPTO is selected, measurement recording will not take place until the OURX935,00003F5 1902JAN081/1 1611 122208 PN=52 Menu Items on Display (D) Implement Select Code Device or System Manual Select Switch Auto Seek (Default) First Reporting Device or System Impl Switch:
AS Implement Switch with Auto Seek RPTO Rear Power TakeOff HCU Hitch Control Unit SCV IV Selective Control Valve I—V