John Deere Omar287594 — Programming Lights

Lights Road Position (P): Programmed lighting will remain on for 90 seconds, then shut off automatically. Each additional time switch is turned counterclockwise adds 30 seconds to time lights remain ON up to 3 minutes maximum. Turns on high/low beam road lights (C), front clearance lights (L), extremity clearance lights (Y), and red tail lights (V). NOTE: Refer to PROGRAMMING LIGHTS for set­up information. Automatic Battery Protection Feature To prevent battery discharge if headlights or field lights are left on accidentally after shutting off engine and removing ignition key, the electrical system will automatically start following sequence:

After 30 minutes have elapsed, lights will turn on and off 5 times After 5th time, lights will turn back on and stay lit for about 60 seconds After 60 seconds, lights will go off and stay off to prevent complete battery discharge Field Position (Q) : Turns on clear­lens lighting (A H and J and M) programmed for each Field position. Delayed Shut­Down Position (R) ((If Equipped)): Momentarily turn light switchcounterclockwise from the OFF position to activate delayed egress lighting. Cancel egress lighting by turning switch clockwise to Road position and then OFF. OURX935,0000075 ­19­05FEB08­2/2 Programmable Lighting State NOTE:

All the clear­lens lights will show a fault, if a fault occurs, except the inner and outer front rooflights. A B A—Light Programmed ON B—Light Programmed Off C—Light Programmed On, Faulted D—Light Programmed Off, Faulted RXA0080526 —UN—10MAY05 C D OURX935,00000AE ­19­29JUL05­1/1 20­2 122208 PN=59