Lights To program field lights, rotate Light Switch to field position, depress Field Light Switch, and observe CommandCenter display. All clearlens lights are selectable when programming Field 1 or 2 positions. all clearlens lighting and again moving the dimmer switch will allow for a fourth option for programmable lighting. Egress (Delayed Shutdown) Position (If Equipped): Turn light switch knob to Egress (clock) position and observe CommandCenter display. Rotate Command dial (C) to highlight desired light, then press Select Switch (D) to turn light ON (white indicator) or OFF (black indicator). Changes to ON/OFF settings take place immediately.
Programming Egress lighting is the same as Field lighting with all clearlens lights selectable. Only operator selected clearlens lights will come ON when switch knob is moved to Egress (Delayed Shutdown) position. Moving dimmer switch to high beam will give a second option to program lights. Normally one field light position is programmed to operate only certain lights, such as rear facing field lights. Moving dimmer switch to high beam will give a second option to program lights such as all rear facing lights and side mounted roof lights. The other position is used to operate OURX935,0000788 1909AUG052/2 Operating Turn Signals and High/Low Beam NOTE:
When turn signal is activated, a short audible chirping sound will be heard. B Turn Signals: RXA0080014 —UN—10AUG05 Push turn signal lever (A) up for a right turn, or pull down for a left turn. Return lever immediately to center position. Turn signal light continues to flash for additional 50 m (164 ft) of tractor travel, then switches off automatically. High/Low Beam: A CAUTION: Avoid injury caused by accidental collision with another vehicle. Always comply with traffic regulations when driving tractor on a road. Dim headlights to lowbeam for oncoming vehicles.
A—Turn Signal Lever B—LeftHand Reverser (If equipped) Push turn signal lever forward to activate high beam headlights; high beam indicator will come on. Pull lever into center position to operate low beam. Pull lever toward you and release to flashtopass high beams. Dim headlights for oncoming vehicles. OURX935,000078A 1918AUG051/1 Operating Hazard Light Push Hazard Light Switch (A) to activate flashing amber hazard lights at front and rear. A RXA0068232 —UN—27AUG03 A—Hazard Light Switch OURX935,000078C 1929JUL051/1 204 122208 PN=61