Operator Station Installing Mobile Radio and Antenna CAUTION: Under no circumstances should mobile radio antenna be mounted to rear of cab or antenna cable be routed near harness for electrical system controllers or operator controls. Failure to follow these precautions could expose operator to radio frequency energy levels higher than recommended by American National Standards Institute (ANSI) and/or could cause undesirable performance of electronically controlled systems. RXA0099991 —UN—12DEC08 IMPORTANT: Avoid possible interference of tractor electronics by keeping radio, power and antenna cables close to the cab roof. Mobile Radio Bracket With Antenna Cable CAUTION:
Prevent possible personal injury. Disconnect battery ground cable before any electrical repair. NOTE: Only tractors ordered mobile ready from factory have mounting plate, antenna cable, and antenna included. For tractors ordered not mobile radio ready and do not include a mounting plate or wiring harness unless specified when tractor was ordered. See John Deere dealer to install mobile radio. for tractors that are mobile radio ready, follow installation steps below. RXA0099993 —UN—12DEC08 Remove existing entertainment radio bezel to gain access to power leads (E) and antenna cable (B). Mobile Radio Antenna Location CAUTION: Prevent possible personal injury.
Disconnect battery ground cable before any electrical repair. RXA0099995 —UN—12DEC08 Remove existing entertainment radio bezel to gain access to power leads (E) and antenna cable (B). Power leads are preinstalled, locate red wire #272 for switch operation. Should radio operation require battery power at all times, use red wire #262. Black wire is mobile radio ground. Mobile Radio Mounted In Right Rear Cab Corner Connect antenna cable to radio. Remove rain cap on outer roof and attach nonground plane type antenna to the mount. Antenna mount is 11/8 in. 24 thread. The cable connector for radio is a PL259 type. Adapters are available through radio equipment suppliers.
A—Rotary Beacon Connector B—Mobile Radio Antenna C—AM/FM Connector D—AM/FM Antenna E—Mobile Radio Power Leads F—Console Light G—Roof Trim H—Mobile Radio Bracket NOTE: Antenna should be trimmed to appropriate variable standing wave ratio (VSWR). A professional installer is recommended. Install the radio bezel after the mobile radio cable and wires are routed. OURX935,0000495 1915DEC081/1 257 122208 PN=70