Operator Station Configuring Tractor For GPS/Radar Tractors equipped with radar must be reconfigured when switching to GPS receiver as the true ground speed input signal. To configure tractor: 1. Remove screw (A) and CommandCenter (B). 2. Inside righthand console locate one wire lead marked and one marked ”Radar”. 3. Remove radar plug (C) from wiring connector (E). 4. Remove GPS plug (D) from dust cap (F). 5. Install GPS plug into connector and radar plug into dust cap. 6. Install CommandCenter with previously removed screw. RXA0082000 —UN—08JUL05 Remove CommandCenter panel Tractors not equipped with radar, but wanting to add a GPS signal require two controller addresses to be changed.
Contact your John Deere dealer for assistance. A—Screw B—CommandCenter C—Radar Plug D—GPS Plug E—Connector F—Dust Cap RXA0082002 —UN—08JUL05 Connect GPS OURX935,00001D1 1902JAN081/1 2511 122208 PN=74