Operating Powershift Transmission Shifting the Transmission + D - - RXA0083193 —UN—09AUG05 B C + P A N A—Rear Slot B—Right Slot C—Center Slot D—Front Slot Shift Lever Positions However, if transmission is in 13F or higher and tractor is stopped by using clutch or shifting to NEUTRAL and not shifted through reverse, transmission will be in 13F when shifted forward again. PARK Rear slot (A)—Park brake applied when lever is fully forward in slot. NEUTRAL — Right slot (B)—Park brake is released when lever is moved to the right slot. Shifting—WITHOUT Using Clutch Pedal Reverse Center slot (C)—Tractor will begin moving rearward when lever enters this slot.
Push lever forward for downshifts and pull rearward for upshifts. Hold lever to shift up or down to selected gear. Transmission will shift one gear at a time until lever is released. Forward Front slot (D)—Tractor will begin moving forward when lever enters this slot. Push lever forward for upshifts and pull rearward for downshifts. ”Bump” lever to quickly shift up or down to selected gear. Transmission will skip gears, if lever is moved faster than transmission can shift. Commanded Gears NOTE: Use a higher gear and lower engine speed for light load operations to save fuel and reduce wear. Under full load conditions, use full throttle engine speed.
Shifting—Using Clutch Pedal Hold lever to shift up or down until desired gear is displayed. Transmission will go into commanded gear when clutch pedal is released. Transmission will start out in 7F and 2R after engine is started. These are the default gears. 1 ”Bump” lever to quickly shift up or down until desired gear is displayed. Transmission will go into commanded gear when clutch pedal is released. Once in forward or reverse, commanded gear changes to the last gear of operation before shifting to NEUTRAL. Rapid Shift The initial commanded gear can also be changed prior to initiating motion to match the operation.
To reach transport speed quickly, depress clutch pedal and rapidly shift lever to 13F. Transmission will shift directly to 13F when clutch is released. Once tractor is underway in 13F, ”bump” shift lever to 16F. FORWARD gears (1 through 13) and REVERSE gears (1 through 3) may be preselected by depressing clutch pedal and pushing or pulling shift lever until desired gear is displayed. Shuttle Shifting (Direction Change) Cold Weather Starting Moving shift lever between FORWARD and REVERSE slots causes transmission to modulate directly to opposite direction of travel without clutching or braking.
Transmission will not shift into 15F and 16F speeds until normal operating temperature has been reached. Delayed shifting may also be noticeable. Shuttle shift occurs between last commanded forward and reverse gears. Shifting From Reverse Commanded gear will be 2R, regardless of previous reverse gear, when shifting from 14F—16F to reverse. The highest forward gear transmission will automatically shift to is 11F, when shifting from reverse. For example, if transmission is in 13F and is shifted to reverse, and then back to forward, transmission will automatically shift to 11F. Ground Speed Matching CAUTION: Avoid possible accident and injury from loss of vehicle control. Never coast down hill.
Continued on next page OURX935,00004A4 1931JAN061/2 412 122208 PN=94