Camshaft and Timing Gear Train TIMING GEAR COVER - EARLY 3TNA72 (430 LGT) NOTE: It is not necessary to remove auxiliary drive cover and gasket, if equipped, or end cover and o-ring to remove timing gear cover. Removal/Installation 6. Remove 14 mounting cap screws and timing gear cover. 1. Remove alternator and belt. 2. Remove crankshaft pulley cap screw and washer. Installation is done in the reverse order of removal. 3. Remove crankshaft pulley using a two-jaw puller kit. Tighten all mounting cap screws to 9 N•m (78 lb-in.) . 1 Align pin in crankshaft pulley with hole in crankshaft gear. Install crankshaft pulley. 4. Remove cotter pin and washer to disconnect fuel shutoff solenoid linkage.
Adjust alternator drive belt tension. (See Checks, Tests and Adjustments in this section.) Cotter Pin and Washer Hole Pin M35272 5. Remove two nuts and one cap screw to remove bracket and fuel shutoff solenoid. M35295 1-62 4/7/95 AllTractorManuals.com Nut (2) 9 N•m (78 lb-in.) Cap Screw 9 N•m (78 lb-in.) M35294 M35294