PARKING l When operating on slopes, remember the following points: o When driving on a slope, always drive directly up or down it. Never drive horizon- tally or diagonally across the slope, as this may cause the machine to roll over or slip sideways. o As far as possible, avoid turn- ing the machine on a slope. It may cuase the machine to roll over or slip sideways, l When parking the machine, park it in a safe place outside the working area, or in the specified place. The following factors should be considered when choosing a parking place: it should be on flat, firm ground where there is no danger of rock- falls, landslides or floods.
l If the machine has to be parked on a slope, it should be parked facing directly up or down the slope, and chocks should be placed under the tires. l When leaving the machine, always lower the work equipment completely to the ground, and put all control levers in neutral. Next, apply the parking brake and lock all levers. Then put blocks under the tires. l After stopping the engine, always remove the starting key. -lO- W-03667