PRECAUTIONS FOR REMOVAL, INSTALLATION, AND STORAGE OF ATTACHMENTS Before starting removal and installation of attachments, decide the team leader. Do not allow anyone except the authorized workers close to the machine or attachment. Place attachments that have been removed from the machine in a safe place so that they do not fall. Put up a fence around the attachments and take other measures to prevent unauthorized persons from entering. HDO1041L Figure 34 PRECAUTIONS WHEN WORKING ON MACHINE When carrying out maintenance operations on the machine, keep the area around your feet clean and tidy to prevent you from falling. Always do the following; Do not spill oil or grease.
Do not leave tools laying about. Watch your step when walking. Never jump down from the machine. When getting on or off the machine, use the steps and handrails, and maintain a three-point contact (both feet and one hand or both hands and one foot) to support yourself securely. ARO1380L Figure 35 If the job requires it, wear protective clothing. To prevent injury from slipping or falling, when working on the hood or covers, never use any part except the inspection passage fitted with nonslip pads. LOCK INSPECTION COVERS When carrying out maintenance with the inspection cover open, lock the cover securely in position with the lock bar.
If maintenance work is carried out with the inspection cover open but not locked, there is danger that it may suddenly close and cause injury if there is a gust of wind. CRUSHING PREVENTION AND CUTTING PREVENTION You should always have at least two people working together if the engine must be run during service. One person needs to remain in the operator's seat, ready to work the controls or stop the machine and shut off the engine. Unless you are instructed otherwise, never attempt adjustments while the machine is moving or while the engine is running. Stay clear of all rotating parts and moving parts. 022-00058E Operation and Maintenance Manual Safety 1-33