2016 Isuzu Truck CMVSS 101 and FMVSS 101 – CONTROLS AND DISPLAYS Applies to all models of incomplete vehicles contained in this book with a 4536 kg (10,000 lb) GVWR or more TYPE 1 The following statement is applicable to all models of incomplete vehicles contained in this book with a GVWR of more than 4536 kg (10,000 lb) (unless otherwise noted on the cover). This incomplete vehicle, when completed, will conform to CMVSS 101 and FMVSS 101 providing no alterations are made which affect this location, identification, or illumination of the controls and displays identified below or the location, travel and type of seat.
If the seat is installed by the final stage manufacturer, the visibility and operation of the controls and displays listed below must meet the requirements of the standard: Vehicle and system controls and displays including:
Accelerator Horn control Brake failure warning Ignition switch (engine start & stop control) * Brake failure displays Illumination intensity control Clutch Low fuel indicator Driver’s sunvisor Manual/automatic transmission shift lever Electrical charge indicator * Odometer Engine coolant temperature display Engine oil pressure display Engine idle speed control Service brake Fuel level display * Speedometer Hazard warning control & indicator Steering wheel Master lighting switch (includes clearance lamp, identification lamp, and tail lamp control) Turn signal, control & indicator Heating & air conditioning system control Windshield defrosting & defogging controls Heating system & air conditioning system fan Windshield washer control Gear position display Windshield wiper control High beam indicator & control Anti-lock brake failure warning display If the intermediate or final stage manufacturer installs any of the above controls and displays, those controls and displays will also have to meet the requirements of this standard.
* For CMVSS only, when Canadian option is specified. PAGE 1.4