106 FUEL TANK REF NO. PART NUMBER QTY DESCRIPTION REMARKS 25. 106-386 2 FLG LOCKNUT (M8-1.25) 24. 105-829 6 FLG LK BOLT (1/2-NC X 1") 26. 320-591 1 TANK CRADLE 27. 305-656 - LEFT OUTSIDE FENDER 28. 117-425 AR LINER PAD (.12" THK) SEE FOOTNOTE 2 117-463 AR LINER PAD (.25" THK) 29. 313-820 1 TREAD, FUEL 30. 107-001 8 FLG LK SCREW (M10-1.50 X 25mm) 31. 117-442 AR SUPPORT MAT SEE FOOTNOTE 1 32. 106-198 2 FLG LOCKNUT (1/2-NC, GD8) 34. 105-831 2 FLG LK BOLT (1/2-NC X 1-1/2") 33. 313-909 1 LEFT AIR DEFLECTOR 35. 110-333 1 BOLT-ON CLAMP (1") 36. 105-033 1 BOLT (5/16-NC X 2") 37. 117-671 1 ABRASION SLEEVE (1" X 12") 38. 107-778 2 SCREW (M8-1.25 X 30mm, BUT SOC) 39. 107-629 2 WASHER (M8) 40.
105-003 1 FLG LOCKNUT (5/16-NC) 41. 105-1190 5 BOLT (#10-24 X 1-1/4") NOT SHOWN: FOOTNOTES: 1. LAYER SUPPORT MAT BETWEEN LEDGE OF TANK AND UNDERSIDE OF STEP UNTIL FIRM PRESSURE IS REQUIRED TO ALIGN SLOTS AND INSERT SCREWS 2. ARRANGE LINER PADS IN AN EVEN PATTERN ON INTERIOR SURFACES OF THE SIDE PLATES, BOTTOM PLATE AND PADS UNTIL THE LEAST MOVEMENT POSSIBLE HAS BEED ACCOMPLISHED. ONCE FILLED THE TANK SHOULD NOT SHIFT. PLATE. USE .12 THICK AND .25 THICK TO PROVIDE A SNUG FIT FOR THE TANK. APPLY AND ADJUST THE LINER NOTE: 05 ID0024290