Vehicle Access and Features 1 2 WARNING Do not allow loose clothing to get near moving en- gine parts. To do so could result in serious per- sonal injury. 3 CAUTION Ensure the shift lever will clear the floor opening when the cab is tilted to prevent damage to the shift lever. 4 Do not raise the cab until all loose items inside the cab are removed or fastened down and the doors are closed. If the cab is equipped with exterior air lines, be sure the air lines will be clear of the body lock. 09/09/97 1. Signal Flasher (located at upper left of fuse panel) 2. Warning Chime (located at right side of fuse panel) 3. Warning Buzzer (located at lower left of fuse panel) 4.
Fuse/Relay/Circuit Breaker Panel f541760 1. Apply the parking brakes and chock the tires. Fig. 2.13, Fuse/Relay/Circuit Breaker Identification 2. The handle for the cab lock control is located on the lower front face of the driver’s seat ( Fig. 2.14 ). Remove the handle from the housing. To Tilt the Cab WARNING 3. Insert the cab lock handle in the lock control lo- cated on the passenger’s side of the rear cab panel ( Fig. 2.15 ). Push the safety hook knob inward, then rotate the handle counterclockwise and pull the handle outward. The handle will still be engaged. Do not release the cab until the transmission has been put into neutral, the ignition turned off, and the parking brake set.
Failure to observe these pre- cautions could result in serious personal injury. 2.13