CONTROLS - Steering Column Controls 2. The lever will automatically return when the lever is released. The blue indicator light in the instrument panel will momentarily turn ON and the high beams will flash. The high beams will not remain on if the lever is still pressed. 1. Push the small button on the end of the turn stalk 3 2. To return to previous beam: pull the lever towards the steering wheel again. The blue indicator light in the instrument panel will turn ON and the high beams will turn on. NOTE Operate the Windshield Wipers This vehicle is equipped with a two speed, intermittent windshield wiper system.
The windshield wiper system is integrated with the exterior lights so that the low beam headlights will turn on when the windshield wipers turn on. The “flash to pass” functionality of the headlight switch is not available for ve- hicles manufactured with High Intensi- ty Discharge (HID) headlamps. Please check with local regulations regarding restrictions on using high beam flash- ing. How to Momentarily Flash High Beams The "flash to pass" high beam function is operated by the same steering column lever for the turn signals. The high beam flash to pass will work if the headlights are not on. 1. Gently push the turn signal lever, away from the steering wheel.
WARNING NOTE Clean blades regularly with a damp cloth to remove road film and wax buildup. Do not drive with worn or dirty wiper blades. They can reduce visibili- ty, making driving hazardous which may lead to an injury accident result- ing in death or personal injury. Continued pressing of the high beam flash will not keep the high beams on. How to Flash Marker and Clearance Lights A button on the turn stalk will momentarily flash the marker and clearance lights when pushed. Y53-6047-2HEN (03/18) 105