CONTROLS - Guide to the Warning Symbols You may see this appear if the system has detected a situation where the starter is too hot and needs to cool down. Alternatively, you may see it when the engine grid heater is on and needs some time to warm up. (PACCAR PX and Cummins ISL engines) Illuminates when optional LDW system is not able to track the vehicle's position within the lane. Illuminates when water has been detected in the fuel. Lights, High Beam NOTE 3 NOTE For vehicles equipped with Lane De- parture Warning, please refer to Lane Departure Warning Driver's Guide for additional information. Some engines are equipped with an engine starting motor protection fea- ture.
If the starting motor is engaged for 30 or more seconds, without the engine starting, the starter will be locked out from operating, allowing for proper cooling of the starting motor. During this time, the 'Wait-To-Start' lamp will flash for 2 minutes. Once the lamp stops flashing, the starting motor will be allowed to function. Illuminates when the high beams are on. This icon will flash with audible alarm if the headlamps are left ON when the door is opened and the key switch is OFF. In addition, this icon will flash, but without an audible alarm, if there is a problem with the low beam headlights or the low beam headlight wiring.
In such event, the high beam headlights will turn on at 50% normal brightness. Power Take-off (PTO) Pump Mode Illuminates with remote throttle application. Indicates pump mode is active. Power Take-off (PTO) NOTE Lane Departure Warning (LDW) Engines equipped with air starting mo- tors require a minimum of 70 psi (480 kPa). Illuminates when the PTO is engaged. Fuel Water In Fuel (WIF) Y53-6047-2HEN (03/18) 83