. SAFETY PRECAUTIONS FOR OPERATION STARTING WITH BOOSTER CABLES If any mistake is made in the method of connecting the booster cables, it may cause the battery to explode, so always do as follows. rubber gloves when starting normal machine with the same cable, carry out the starting machine, do not allow the two normal machine and problem cables, be careful not to let the OPERATION 2 - 25 the engine with booster cable. When connecting a normal ma booster cables, always use a battery voltage as the problem When starting with a booste operation with two workers (on seat and the other working with When starting from another machines to touch.
When connecting the booster c the OFF position for both the machine. There is a hazard that power is connected. Be sure to connect the positive booster cables. Disconnect the first when removing them. When removing the booster c booster cable clips touch each machine. For details of the starting proce see "Starting Engine with Boos OPERATION section. CHECKS BEFORE OPERATION If t he checks before starting are n ot carried out properly, the machine will be un able to displ ay its full performance and there is also danger that it m ay lead to serious personal injury or death.
When carrying out the checks, m ove the machine to a wide area where there a re no obstru ctions, and pay c arefu attention to the surrounding area. Do not allow anyone near the machine. Always wear the seatbelt. Th thrown out of the operator's se the brakes are applied suddenl Check that the movement of th on the control pattern card. I immediately with the correct co Check the operating condition arm, boom, travel, and swing s Check for any problem in the s heat, smell, or gauges; check a or fuel. If any problem is found, carry o