9 CHECKS BEFORE START C Fuel supply The following functions are helpful when adding the fuel. The fueling progress can be monitored by a buzzer sound. C Coolant Temperature Gauge Procedure 1. Press the user setting switch(switch 1) or the display selector switch(switch 5) on the meter with the key OFF. (Keep the key at OFF.) To avoid personal injury or death: A Do not open the radiator cap during or just after operation. Hot coolant may gush out and scald you. Wait for the coolant to cool down before opening the cap. With the starter key at the " RUN " position, the coolant temperature is indicated. 2. Add fuel. 3. The buzzer sound interval changes according to the amount fuel added.
As the fuel amount becomes close to full, the buzzer sound changes to continuous beeping. (1) Coolant temperature gauge A If the fuel is poured too fast, the buzzer may not sound according to the fueling process. A The moment when the fuel tank is nearly full, the buzzer starts beeping. A Look into the fuel tank when pouring the fuel. Listen to the buzzer sound for a rough estimate of the fill-up progress. If the coolant temperature indicator is near " H ", take the steps below. Depending on the coolant temperature, the warning message "Water temp is rising" or "Overheat Engine to idle for cooling" appears. In either case too, follow the same procedure below. 1. Discontinue the job. 2.
Reduce engine rpm's to idle and keep it at idle for 5 minutes. 3. Stop the engine and check the following points (1)-(4). (1) Low coolant level or leak (2) Fan belt tension (3) Mud or dust deposits on radiator (4) Hydraulic oil leak