MICHIG11111 CLARK EQUIPMENT CONSTRUCTION MACHINERY DIVISION 19 20 21 22 23 24 25 11 Places on cantrci cover face. TYPICAL SECTION 18 17 Places on front & rear face of case. TYPICAL SECTION 11 16 SECTION A -A 15 26 14 13 12 9 FRONT — INSIDE 10 11 REAR — INSIDE SECTION C-C TS-4670-P Item No. Port No. Description TRANSMISSION CASE AND INTERNAL TUBING No. Re q 'd. Item No. Part No. No. Description Re q 'd. 1 217574 CASE ASSY, Trans. (Inc.
1 thru 26) 1 14 6H-29 CLIP, Tube 1 2 217708 *TUBE, 1st Clutch Pressure 1 15 619018 WASHER, Clip to Case 1 3 217711 *TUBE, Splitter Clutch Lube 1 16 1H-414 RIVET, Clip to Case 1 4 217710 *TUBE, 2nd Clutch Lube 1 17 6H-32 CLIP, Dipstick Tube 1 5 217709 *TUBE, 2nd Clutch Pressure 1 18 217704 *TUBE, Reverse to Idler X-Over Lube 1 6 222067 SLEEVE, Tube 10 19 217706 *TUBE, 4th Clutch Pressure 1 7 222067 SLEEVE, Tube 18 20 217699 *TUBE, Reverse Clutch Pressure 1 8 217698 *TUBE, 2nd to 1st X-Over Lube 1 21 217703 *TUBE, Reverse Clutch Lube 1 9 6H-29 CLIP, Tube 1 22 217707 *TUBE, 3rd Clutch Lube 1 10 1H-534 RIVET, Clip to Case 1 23 217701 *TUBE, Input Lube 1 11 619019 WASHER, Clip to Case 1 24 217700 .
*TUBE, Input Clutch Pressure 1 12 1H-518 RIVET, Clip to Case 1 25 217705 *TUBE, 3rd Clutch Pressure 1 13 619019 WASHER, Clip to Case 1 26 217702 *TUBE, 3rd to 4th X-Over Lube 1 *NOTE: Use two 222067 sleeve (Item 6 or 7) when replacing any of the above tubes, one at each end of tube. Use 943374 Tube Expander to expand tube into sleeve. WHEN ORDERING PARTS, ALWAYS STATE MODEL AND SERIAL NO. OF MACHINE [ 18 ] PM 2137