SAFE OPERATION - 5 11.Always maintain the correct tire pressure. Do not inflate tires above the recommended pressure shown in the operator's manual. 6. SERVICING THE TRACTOR Before servicing the tractor, park it on a firm, flat and level surface, set the parking brake, lower all implements to the ground, place the gear shift lever in neutral, stop the engine and remove the key. 1. Allow the tractor time to cool off before working on or near the engine, muffler, radiator, etc. 2. Do not remove radiator cap while coolant is hot. When cool, slowly rotate cap to the first stop and allow sufficient time for excess pressure to escape before removing the cap completely.
If the tractor has a coolant recovery tank, add coolant or water to the tank, not the radiator. (See "Checking Coolant Level" in "DAILY CHECK" in "PERIODIC SERVICE" section.) 3. Always stop the engine before refueling. Avoid spills and overfilling. 4. Do not smoke when working around battery or when refueling. Keep all sparks and flames away from battery and fuel tank. The battery presents an explosive hazard, because it gives off hydrogen and oxygen especially when recharging. 5. Before "jump starting" a dead battery, read and follow all of the instructions. (See "JUMP STARTING" in "OPERATING THE ENGINE" section.) 6. Keep first aid kit and fire extinguisher handy at all times. 7.
Disconnect the battery's ground cable before working on or near electric components. 8. To avoid the possibility of battery explosion, do not use or charge the refillable type battery if the fluid level is below the LOWER ( lower limit level ) mark. Check the fluid level regularly and add distilled water as required so that the fluid level is between the UPPER and LOWER levels. 9. To avoid sparks from an accidental short circuit, always disconnect the battery's ground cable (-) first and reconnect it last. 12.Securely support the tractor when either changing wheels or adjusting the wheel tread width. 13.Make sure that wheel bolts have been tightened to the specified torque.
14.Disconnect the battery's ground cable and stop the engine to avoid the possibility of the machine runaway due to 4WD braking system during testing, service or repair with only rear wheels off the ground. 15.Do not work under any hydraulically supported devices. They can settle, suddenly leak down, or be accidentally lowered. If it is necessary to work under tractor or any machine elements for servicing or adjustment, securely support them with stands or suitable blocking beforehand. 16.Escaping hydraulic fluid under pressure has sufficient force to penetrate skin, causing serious personal injury. Before disconnecting hydraulic lines, be sure to release all residual pressure.
Before applying pressure to the hydraulic system, make sure that all connections are tight and that all lines, pipes, and hoses are free of damage. (1) Battery 10.Do not attempt to mount a tire on a rim. This should be done by a qualified person with the proper equipment.