Introduction Introduction This Operator's manual describes the operation and maintenance of Scania industrial engines. The engines are direct-injection, liquid-cooled, four-stroke, turbocharged diesel engines. Certain engines are also equipped with an SCR system for emission control. The engines are available with different output and engine speed settings. Engine power for the engine ordered is indicated on a plate located on the engine control unit. Note: Only standard components are described in the operator's manual. Information about special equipment is contained in instructions from the various manufacturers.
To ensure the maximum performance and the longest service life for the engine remember the following: Read through the Operator's Manual before starting to use the engine. Even regular users of Scania engines will get new information from the Operator's Manual. Always follow the maintenance instructions. Read the section on safety carefully. Get to know your engine so that you know what it can do and how it works. Always contact a workshop with qualified personnel for maintenance and repair. The information in this manual was correct at the time of going to press. Scania reserves the right to make alterations without prior notice. OPM 100 en-GB 4 © Scania CV AB 2015, Sweden